Attach rest to the riser with bolt provided.
To adjust the center shot, loosen windage bolt and slide rest left or right to desired location and tighten screw.
To adjust launcher arm height, loosen elevation bolt and slide rest up or down to desired location and tighten bolt.
To adjust spring tension, loosen allen screw on spring retainer and turn clockwise for more tension and counter clockwise for less tension. You want just enough tension to raise the launcher arm while fully supporting the arrow. This applies to the Right handed rest. *Reverse instructions for Left handed rest.
Prepare top limb surface by cleaning with denatured alcohol.
Remove paper backing and adhere pad to clean limb surface.
Tie limb driver cord around the limb over the pad using a half hitch knot.
Run cord down through cord hole in stopper. Keep downward tension on cord while pushing launcher arm down toward the shelf and tighten cord set screw to hold cord and rest in place. Tighten mounting bracket set screw.
Draw bow back and make sure launcher arm rises as cord goes slack. Let bow down and make sure launcher arm lowers as cord is again pulled taught. Do this with an arrow on the string in case of misfire to prevent dry fire.
Prepare inside surface of the containment cage by cleaning with denatured alcohol. Apply moleskin to inside surface where needed.