Attach rest to the riser with bolt provided.
To adjust the center shot, loosen windage bolt and slide rest left or right to desired location and tighten windage bolt.
To adjust launcher blade height, loosen elevation bolt and slide rest up or down to desired location and tighten elevation bolt.
To adjust spring tension, loosen allen screw on spring retainer and turn upwards for more tension and downwards for less tension. You want just enough tension to raise the launcher blade while fully supporting the arrow.
Choose top or bottom limb to attach the limb driver cord in order to avoid interference with other accessories.
Prepare limb surface by cleaning the denatured alcohol. Remove paper backing and adhere pad to clean limb surface.
Tie limb driver cord around the limb over the pad using a half hitch knot.
If the cord is attached to the top limb, run the cord through the top limb cord hole on the stopper. Bottom limb cord hole for the bottom limb. Keep tension on cord while pushing launcher arm down toward the shelf and tighten cord set screw to hold cord and rest in place. Tighten mounting bracket set screw.
Draw bow back and make sure launcher blade rises as cord goes slack. Let bow down and make sure launcher blade lowers as cord is again pulled taught. Do this with an arrow on the string in case of misfire to prevent dry fire.